Right is how the kludge looked when I got home. Gear and burning the clutch once I got off the highway. On the nearest highway and made it home, though I largely stuck with third The bushing and slit open a piece of fuel line I had in the trunk, usingĮlectric tape to hold it together when it slipped over the ball. To third gear and failed trying for fourth. Tried again with tie-wraps to hold it all in place. The mangled bushing back in again, it failed on the second/third shift when The shift linkage fell apart passing through neutral. I was driving to an electronics auction yesterday morning when Plastic having enough give to fit over the ball, but let's start at theīeginning. I wanted a template) had the look and feel of plastic. Mess that was left of the first one (and the one I later blew apart because I say rubber or plastic because the mangled The plastic or nylon snap fitting, not the end with the rubber or plasticīushing that fits over a ball. It seems to me they failed on the end with I've owned my Omni since it was new, 1986, and I remember having these shift How to make the shifter rod rubber bushings that are no longer availableĬopyright 2011 by Morris Rosenthal All Rights Reserved Shift Linkage Rod Bushing - How to replace the shifter rod plasticīushings that are no longer available from Dodge
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |